Interior Installation - HouseWarmer HWDV080DVN-2 Installation Instructions And Owner's Manual

1
SEE OTHER SIDE FOR HWDV080
Trace the template wall hole and (if applicable) the gas inlet hole onto the wall. Mark the six (6) wall mounting plate screw
2
holes onto the wall. The size of the gas inlet hole will depend upon the size of gas pipe coming into the unit. (See page 17,
box 3 and page 18, box 4).
Housewarmer recommends the use of the wall template to properly cut the wall holes and place the heater. If the template is
3
damaged or not included, refer to the table and graphic below for proper alignment of the wall holes and heater.. Be sure the
baseboard does not get in the way.
A
C
E
GAS INLET
27536-0-0610

interiOr inStallatiOn

MOUNTING TEMPLATE FOR
B
F
D
Locate the wall mounting plate template included in your kit
and remove the perforated sections. Use painters tape to secure
the wall mounting plate template onto the interior wall where
the heater will be located. (Template for HWDV080 will be on
the opposite side of the shown template.)
FLOOR LINE
MEASUREMENTS
Model HWDV080(B)DV
A 7 3/8"
B 10 7/8"
C 21"
D 9 1/4"
E 4"
F 6 1/4"
HWDV181(B)DV
11 3/8"
10 7/8"
24 1/2"
9 1/4"
4"
6 1/4"
Page 17