Installing The Acuix Es Fixed Camera; Step 1: Install The Housing - Honeywell ACUIX ES Installation Manual

TM
Installing the ACUIX ES Fixed Camera

Installing the ACUIX ES Fixed Camera

Step 1: Install the Housing

14
Installing the Surface Mount or Indoor Pendant Housing
Note All ACUIX ES pendant/surface mount shipments include both the skirt and top
cap. Use the part appropriate to the installation; the other is a spare part.
Figure 5 Surface Mount and Indoor Pendant Layout
Field wiring access hole
Surface Mount
Surface Mount
1. Select a location to install the surface mount and housing.
2. Pull all the field wiring and power and video connectors through the skirt wiring
access holes.
3. Mount the skirt on the ceiling using the appropriate hardware.
4. Finish pulling field wiring through the skirt and cut the cable length to 6 inches (152
mm).
Indoor Pendant with a Ceiling or Wall Mount
1. Select a location to install the components and applicable mount.
2. Drill the mount hole size into the ceiling or wall. For ceiling and wall mount hole
dimensions see Table 8
3. Before securing the mount to the wall or ceiling, pull the field wiring through the
mount, ensuring that it extends at least 12 inches (305 mm) past the end of the pipe.
4. Screw the housing top cap into the wall or ceiling pipe.
5. Finish pulling the field wiring from the mount through the top cap and cut the cable
length to 6 inches (152 mm).
Top cap
Skirt
Cover
Lower dome
and Figure 6.
Indoor Pendant