Table of Contents
Advertisement
1-8 FORCED PASSIVE ARMING ON/OFF: To use this feature, passive arming must be selected
in menu item 1-1. When turned on, forced passive arming will ensure that the system will passively
arm, even if a zone is left active (open). Forced passive arming occurs one hour after the ignition is
turned off.
1-10 VEHICLE RECOVERY SYSTEM: If Vehicle Recovery System (VRS
) is programmed to the
® ®
can be activated by the user. Refer to the Owner's Guide for additional description.
ON setting, VRS
® ®
1-12 and 1-13 PIN NUMBER: For feature numbers 1-12 and 1-13, the number of presses on the
arm
button sets the first/third digit of the PIN number. Likewise the number of presses on the
disarm
button sets the second/fourth digit of the PIN number. Press both the
and the
disarm
buttons together to set both the first and second or third and fourth digits to "00".
Menu #2 - Advanced Features
2-1 REMOTE SENSOR BYPASS: The system can be programmed to allow remote sensor bypass
or for this feature to be disabled so the sensors cannot be bypassed by the user. The indicator light
flashes provide the indication for the zones selected to be bypassed.
Remote Sensor Bypass ON
After arming, immediately press the
button once. The indicator lights will flash 3 times and
all the sensor warn-away zones will be bypassed.
After arming, immediately press the
button twice. The indicator lights will flash 4 times and
all the sensor warn-away and full alarm zones will be bypassed. All remaining zones are still active.
NOTE: To bypass the Ultrasonic sensors, after arming press the
button twice.
Remote Sensor Bypass OFF
No zones are bypassed. Pressing arm
again will repeat the arm output, and the unit will remain
in the armed state.
36
©
2005
Directed Electronics, Inc. all rights reserved
Hide quick links:
Advertisement
Table of Contents
