Viper 480XV Installation Manual page 11

H2/2 ORANGE/BLACK (-) retained accessory output
N N O O T T E E : An additional relay (not supplied) is required for most applications.
Connect this wire to the accessory wire at the ignition switch that powers the accessories in the
vehicle such as the radio. This wire will retain power after the ignition key is turned off. This output
turns off when a door is open/closed or the system is armed.
H2/3 GREY/BLACK (-) channel output 6 (200mA)
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 6
is pressed. This output can be programmed to provide the several types of outputs (see Menu #3 -
Advanced Features section)
H2/4 WHITE/BLACK (-) channel output 5 (200mA)
See H2/3 description.
H2/5 VIOLET/BLACK (-) channel output 4 (200mA)
See H2/3 description.
IMPORTANT! Never use these wires (H2/3, H2/4, H2/5) to drive anything but a relay
or a low-current input! This transistorised output can only supply 200 mA, and
connecting directly to a solenoid, motor, or other high-current device will cause the
module to fail.
2005
©
Directed Electronics, Inc. all rights reserved
11