Feature Descriptions - Avital 2200 Installation Manual

feature descriptions

1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter is
used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. Passive
arming is indicated by the rapid flashing of the LED when the last protected entry point is closed.
2 CONFIRMATION CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of
the system.
3 IGNITION-CONTROLLED DOOR LOCK/UNLOCK ON/OFF: When turned on, the doors will lock three seconds
after the ignition is turned on and unlock when the ignition is turned off. If the ignition key is turned on while
the vehicle door(s) are open, the door(s) will not lock.
4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1, then the system can be programmed
to either lock the doors when passive arming occurs, or only lock the doors when the system is armed with the
transmitter. Active locking means the system will not lock the doors when it passively arms. Passive locking
means that the system will lock the doors when it passively arms.
5 DOOR LOCK PULSE DURATION: Some European vehicles, such as Mercedes-Benz and Audi, require longer lock
and unlock pulses to operate the vacuum pump. Programming the system to provide 3.5 second pulses will
accommodate door lock interface in these vehicles. The default setting is 0.8 second door lock pulses. See
Mercedes-Benz and Audi - 1985 and Newer (Type E Door Locks section) diagram.
6 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to unlock the doors. When
the double pulse unlock feature is turned on, either the (+) unlock wire (H3/1 GREEN) or the (-) unlock wire
(H3/3 BLUE) wire will supply two pulses instead of a single pulse. This makes it possible to directly interface
with double pulse vehicles without any extra parts.
NOTE: The second unlock output feature (H2/1 BLUE wire) is not available if the double pulse
unlock feature is turned on.
7 STEALTH CODING
Stealth Coding ™ Technology is a feature that uses a mathematical formula to change the system's code each time
the transmitter and receiver communicate. This makes the group of bits or "word" from the transmitter very long.
The longer the word is, the easier it is to block its transmission to the unit. Disabling the Stealth Coding
Technology feature lets the receiver ignore the Stealth Coding
result, the unit may have better range with Stealth Coding
26
™ TECHNOLOGY ON/OFF: This system features Stealth Coding
™ Technology part of the transmitted word. As a
™ Technology off.
© 2001 Directed Electronics, Inc. Vista, CA
™ Technology as an option.
™