Transmitter Configuration - Avital 2200 Installation Manual

4. Press the transmitter button. While HOLDING the Valet
mitter button that you wish to assign to that channel. The unit will chirp indicating
successful programming. You cannot teach a transmitter button to the system more than once.
NOTE: For Channel 7, press Button I (see Transmitter Configuration section of this guide) to
program the Auto-learn Standard Configuration on a three-button transmitter.
5. Release. Once the code is learned, the Valet
You can advance from one channel to another by releasing the Valet
channels and then HOLDING it. For example, if you want to program Channel Three after programming Channel
One, release the Valet ® /Program button. Press it twice and release it to advance to Channel Three. Then press it once
more and HOLD it. The siren will chirp three times to confirm it is ready to receive the code from the transmitter.
Code Learning will be exited if:
I Ignition is turned off.
I Door is closed.
I Valet
® /Program button is pressed too many times.
I More than 15 seconds elapses between steps.
One long chirp indicates that Code Learning has been exited.

transmitter configuration

The transmitters can be programmed with the Standard Configuration by using the Channel 7 Auto-learn* func-
tion in the Transmitter/Receiver Remote Control Code Learning. When programmed for Standard Configuration, the
3-button transmitter buttons are assigned to the following functions:
Button I ....................................operates ............................................Arm/Disarm/Panic
Button II ..................................operates ............................................Channel Two
Button III ..................................operates ............................................Channel Three
*NOTE: The Auto-learn function cannot be used to program an optional four-button transmitter.For
a four-button transmitter, the different channels must be taught to the transmitter individually.
© 2001 Directed Electronics, Inc. Vista, CA
® /Program switch, press the trans-
® /Program button can be released.
® /Program button and tapping it to advance
23