Table of Contents
Advertisement
Figure 9. Work with Remote System (X.25) Information
Type option 1 (Add) at the input-capable top list entry to go to the Add TCP/IP
Remote System (ADDTCPRSI) display, as shown in Figure 10.
Figure 10. Add Remote System (X.25) Information
The network controller used by iSeries TCP/IP does not allow you to specify X.25
user facilities. However, some of the values usually configured on a controller,
using the ADDTCPRSI command, allow you to configure each X.25 remote system.
These values include reverse charging, packet sizes, and window sizes.
Use the following CL command to enter the information as shown in the display
above:
Notes:
1. Specifying remote system information for an X.25 DDN interface causes that
information to be used instead of the DDN conversion algorithm. The DDN
conversion algorithm is used only for a connection with DDN specified as *YES
when you try to connect to a host that is not defined in the remote system
Chapter 1. Configuring TCP/IP
17
Advertisement
Table of Contents
