Table of Contents
Advertisement
Figure 32. Confirm End of TCP/IP Connections
To end the TCP/IP connections, press the Enter key from the Confirm End of
TCP/IP Connections display.
If you decide not to end a TCP/IP connection or if you want to change your
choices, press F12 (Cancel).
Working with Configuration Status
To work with the line description used by an interface:
1. On the Work with TCP/IP Interface Status menu, type 12 in the option field for
each interface that you want to work with.
2. Press the Enter key.
This option issues the WRKCFGSTS (Work with Configuration Status) command
for the line description associated with the interface. Using the options shown in
Figure 33 on page 42 you can vary a line description on or off, display the Work
with Job menu, and display the line description or mode status.
This option cannot be used for IP over SNA interfaces because IP over SNA does
not use specific line descriptions.
41
Chapter 2. TCP/IP: Operation, Management, and Advanced Topics
Advertisement
Table of Contents
