Nexgrill 740-0593A Care And Use Manual page 14

Figure 2240
CSA International
Project 2056659
15 of 25
4. If the burners still do not light, turn the knob
"OFF", wait 5 minutes for any excess gas to
dissipate and repeat lighting procedure or follow
the Match Lighting Instructions on page 14.
5. Check for proper burner flame characteristics.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
make minor adjustments necessary. Burner
flames should be blue and stable with no yellow
tips, excessive noise or lifting. Yellow flames
indicate insufficient air. Noisy flames or flames
that lift away from the burner indicate too much
air (See the "Flame Characteristics" section on
page 19).
TO LIGHT THE ROTISSERIE BURNER
1. Open the lid, push and turn rear burner knob
slowly to "IGNITE/ON" setting; simultaneously
press the electronic ignition button to light the
burner.
2. Once the burner is lit, release the electronic
ignition button and knob.
3. If ignition does not occur in 5 seconds, turn the
knob to "OFF", wait 5 minutes and then repeat
the lighting procedure or light by match.
TO MATCH LIGHT THE GRILL
If a burner will not light after several attempts using the control knobs, the burners may be lit with a match.
WARNING
When lighting, keep your face and hands as far
away from the grill as possible.
CAUTION
Remove the warming rack when using a match
to light the rotisserie burner.
Main Burner
1. If you have already attempted to light the main burner with the igniter, allow 5 minutes for any accumulated
gas to dissipate.
2. Insert a match into the lighting rod (A) as shown in fig.
Ignite the match and insert through the cooking grids (B) to the burner.
3. Press the control knob and rotate to the "IGNITE/HI" setting, continue to press the knob until the burner
ignites. The burner should light immediately.
4. If the burner does not light within seconds turn the knob to the "OFF" position, wait 5 minutes and try again.
Rotisserie Burner
Note: Remove the warming rack when using a match to light the rotisserie burner.
1. If you have already attempted to light the rear rotisserie burner with the igniter, allow 5 minutes for any
accumulated gas to dissipate.
2. Insert a match into the lighting rod (A) as shown in fig. 11. Ignite the match and hold next to the burner (B).
OFF
IGNITE / HI IGNITE / HI
LO
For MB
IGNITE / HI
3
IGNITE / ON
For RB
CAUTION
When using a match to light the grill make sure to
use the attached lighting rod.
11.
14
Fig. 10
Rear Burners
IGNITE / HI IGNITE / ON IGNITE / HI
LO LO LO
Main Burners
OFF
2
1
LO
OFF
2
1