Programming A Security Level - TOTALINE P374-2900 Owner's Manual

Programming a Security Level

Programming a Security Level
When a security level has been programmed, the thermostat will allow
limited adjustment to the setpoints (steps # 8 and 9) and, in security
levels 2 and 3, the thermostat will be forced into the Program On
mode. To disable the security feature, program step #7 to 0; this will
cause steps # 8 and 9 not to appear.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
Select the security level:
0=No security in effect
1=Setpoint range limited
2=1+ program on all times
3=2 + prohibits setpoint
changes
Step #8 appears only
if step #7 is not 0.
Adjust the maximum
allowable heat setpoint
when security is in effect.
(35 - 99 )
Step #9 appears only
if step #7 is not 0.
Adjust the minimum
allowable cool setpoint
when security is in effect.
(35 - 99 )
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
TOTALINE
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
7
0
Setup
8
80
Setup
H
I
H
EAT
9
65
Setup
C
OOL
L
O
Page 8.4
MODE
MODE 8
Press
MODE
Press
MODE
Press
PROGRAM