Dry Contact Operation - TOTALINE P374-2900 Owner's Manual

Dry Contact Operation

Dry Contact Operation
If the dry contact is going to be used, select YES in step #39. If the
dry contact is not going to be used, select NO in step #39 below.
DRY CONTACT POLARITY - The terminals may be set to be
Normally Open (NO) or Normally Closed (NC) in step #40.
If NO is selected the dry contact will operate when it is forced
closed. If NC is selected, the dry contact will operate until it is
forced open.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
YES
Set to YES if the dry
contact will be used.
Set to NO if the dry
contact will not be used.
NO
NC
Dry Contact Polarity:
Normally Open (NO)
Normally Closed (NC).
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
39
Setup
40
Setup
Page 16.2
TOTALINE
MODE
MODE
Press
MODE
16
Press
PROGRAM