Set Clock; Programming Thermostat Schedules - TOTALINE CPE230RF Owner's Manual

Set Clock — The Mode and Override buttons allow you to change the
time and day displayed on the thermostat.
To set the clock, press and hold the Mode and Override buttons for 2 sec-
onds. See Fig. 3. The display will show the Setup annunciator. The current
time will blink on and off. Press the UP ARROW or DOWN ARROW but-
tons until the correct time is shown. Hold down the buttons to quickly move
through the time display. Hold down the Override button while pressing UP
or DOWN ARROW to change the time by hours. The AM and PM annun-
ciators will automatically change. To ensure the schedules are properly fol-
lowed, make sure that AM or PM is correct for the time chosen.
When the correct time is shown, press the Mode button to modify the day
of the week. The current day will blink on and off. Press the UP ARROW and
DOWN ARROW buttons until the correct day is shown. Press and hold the
Mode and Override buttons for 2 seconds again to exit the Set Clock mode.
The transmitter will return to normal operating mode after 60 seconds if
no buttons are pressed.
Fig. 3 — Setting the Clock
Programming Thermostat Schedules — Before programming the
thermostat, plan the thermostat daily schedule. The schedule is divided
into 7 days (Monday through Sunday). Each day can have 2 (Occupied 1,
Unoccupied), 3 (Occupied 1, Occupied 2, Unoccupied), or 4 (Occupied 1,
7