Table of Contents
Advertisement
ANT-BDG Product Specifications
ANT-BDG Specifications
RF Specifications:
Electrical Specifications: • Power: Internally powered Lithium Battery (non-replaceable)
Environmental:
Enclosure:
Dimensions (HWD):
Weight:
Certifications:
ANT-BDG Mounting/Installation
ANT-BDG Tags can be mounted on a variety of items. Where permanent fixing is required VHB double-
sided tape is used (Product number L-TA200); otherwise, the tags may be worn on a necklace or clipped
to clothing.
If you will be fixing personnel photos to the ANT-BDG, use a Badge/Slot Punch capable of a throat
reach of 1/4" (FIG. 7).
Punch-out width = 1.625" (41.27mm)
FIG. 7
ANT-BDG - Slot Punch dimensions
ANT-BDG Antenna Orientation
ANT-BDG ID Badge tags are typically worn on a necklace or clipped to clothing, which typically results
in a vertical antenna orientation. There is a horizontal orientation for the ANT-BDG Tags, but it is
typically reserved for installations that use the ANT-BDG Tags as windshield-mounted vehicle tags.
Anterus RFID Solution
• Tx Frequency: 433 Mhz
• Field strength: < 1600 µV/m
• Modulation: ASK
• Stability: Saw Stabilized
• Battery Life span: approximately 5 years.
Note: All of the Anterus RFID tags run on non-replaceable batteries, which
provide approximately five years of normal use. Additional and replacement tags
are available from AMX. Contact your customer service representative for details.
• Operational temperature: 32º F to 140º F (0º C to 60º C)
• Storage temperature: -4º F to 158º F (-20º C to 70º C)
• Humidity: 5% to 90% (non condensing)
• ABS (ultrasonically sealed) IP 65
• Black
3.38" x 2.12" x .19" (86 mm x 54 mm x 5mm)
0.8 oz. (22.68 grams)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and,
• This device must accept any interference received, including interference that
may cause undesired operation.
The following standards applied in accordance with Article 5 of the directive, 1999/
5/EC:
• EN 300 220-1 V1.2.1 (1997-11)
• ETS 300 683 (1997-03)
Any modification of this device without the express consent of the manufacturer
could void the user authority to operate the equipment.
Depth =.25" (6.35mm)
Punch-out height =
.25" (6.35mm)
Anterus™ RFID Solution
7
Advertisement
Table of Contents
