Table of Contents
Advertisement
Anterus™ RFID Solution
FIG. 1
Anterus RFID Group
ANT-RDR RFID Reader
The ANT-RDR (FG5172) connects to the NetLinx controller to initiate system events whenever an ANT-
TAG Device/Asset tag, or ANT-BDG ID badge passes into its zone (FIG. 2).
AxLink/RF
Status LEDs
FIG. 2
ANT-RDR RFID Reader
2
ANT-RDR
RFID Reader
Front
The ANT-RDR communicates with the NetLinx Master via AXLink, which supports up to
255 devices on a single AXLink bus spanning for a total distance of 3000 feet (915 m).
The ANT-RDR uses a 4-pin 3.5 mm mini-Phoenix (male) connector to provide data and power
to the ANT-RDR via the AXLink bus.
ANT-BDG
Badge Tag
RF Stub Antenna (433 MHz)
8-position
DEVICE
DIP Switch
Rear
ANT-TAG
Device/set Tag
4-pin AxLink
Connector
Anterus RFID Solution
Advertisement
Table of Contents
