Table of Contents
Advertisement
Programming
DEFINE_EVENT
DATA_EVENT[vdvAnterus]
{
ONLINE:
{
}
}
Port Mapping
This module uses a single virtual device:
Port Mapping
Virtual Device
41001:1:0 – Main All
Channels
The channels supported by the COMM module are listed below. These channels are associated with the virtual
device(s) and are independent of the channels associated with the touch panel device.
Virtual Device Channel Events
Channel
251
252
NetLinx Send Commands
There are two sets of NetLinx Send Commands supported by the COMM module, one set of Control
commands and one set of Feedback commands.
Refer to the documentation supplied with the Anterus Duet Module for a full listing and description of
supported NetLinx commands, as well as Installer Tips, Naming Conventions, Programming Notes, etc.
AxLink Programming Overview
The Anterus solution will also work without the Duet module, and all web configuration may be done with
Send Commands, Channels and Levels.
Send Commands
The Anterus solution supports the AxLink Send Commands commands listed below. Note command messages
either do not have a response, or are responded to with a COMMAND - not a string.
Send Commands
RSSI Threshold
RSSI Sensitivity Range
28
SEND_COMMAND vdvAnterus,'PROPERTY-Identifiers,97;98;99'
SEND_COMMAND vdvAnterus,'REINIT'
Channels
Control
All
Description
ON: Device communicating (feedback only)
OFF: Device not communicating (feedback only)
ON: Data initialized (feedback only)
OFF: Data not initialized (feedback only)
The RSSI Upper and Lower Thresholds will be sent from the Master to the
ANT-RDR in a level update message as described in the AXLink
Levels section on page 31.
• The level value is equivalent to the RSSI value with range 0 to 255.
The RSSI Upper and Lower Thresholds will be sent from the Master to the
ANT-RDR in a level update message as described in the AXLink
Levels section on page 31.
• The level value is equivalent to the RSSI value with range 0 to 255.
Feedback
All
Anterus RFID Solution
Advertisement
Table of Contents
