Adjustment Of The Wheel Brushes; Battery - Husqvarna CEORA Operator's Manual

4. Install 5 new blades and screws.
5. Make sure that the blades can pivot freely.
6. If the skid plate was removed, install the skid plate
and the screw. Tightening torque 8 Nm.

6.7 Adjustment of the wheel brushes

The wheel brushes must be adjusted if they are worn.
Wheel brushes are available as accessory.
6.7.1 To adjust the wheel brushes
1. Push the STOP button.
2. Set the product to OFF.
3. Loosen the clips with the flat screwdriver on the
Combi tool and remove the rear bumper.
4. Loosen the screw with a T27 screwdriver to adjust
the wheel brushes. Make sure that the brushes
touches the bottom of the wheel threads.

6.8 Battery

CAUTION:
Charge the battery fully
before you put the product into storage. If
the battery is not fully charged it can cause
damage to the battery.
If the operating time of the product is shorter than usual
between charges, this means that the battery is at the
end of its life cycle. Replace the battery to extend the
operating time.
Note:
The battery life is related to the length of
the season and how many hours a day the product
operates. A long season or many hours of operation
a day means that the battery must be replaced more
regularly.
1691 - 006 - 09.01.2023
0mm
Maintenance - 35