Setting Jumpers - Aaeon SBC-659P User Manual

SBC-659P

Setting jumpers

You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To
"close" a jumper you connect the pins with the clip. To "open" a
jumper you remove the clip. Sometimes a jumper will have three
pins, labeled 1, 2, and 3. In this case you would connect either pins
1 and 2 or 2 and 3.
O p e n
The jumper settings are schematically depicted in this manual as
follows:
O p e n
A pair of needle-nose pliers may be helpful when working with
jumpers.
If you have any doubts about the best hardware configuration for
your application, contact your local distributor or sales representa-
tive before you make any changes.
Generally, you simply need a jumper to make most connections.
1 2 SBC-659P Installation Guide
Closed
Closed
BC-599/596
3
2
1
Closed 2-3
1 2 3
Closed 2-3