Porter-Cable PCB222TS Instruction Manual page 21

AddITIONAL BLAdE AdJuSTmENTS (fIg. X)
. Loosen the two alignment bolts () clockwise, located
on the underside of the table at the front of the saw a
half turn with a 5 mm hex wrench.
. Carefully move the trunnion () toward the right
or left side until the blade is parallel to the miter
gauge slot, and then securely tighten the two bolts
counterclockwise.
3. If the blade is still not parallel to the miter gauge slot,
loosen the two alignment bolts (3) clockwise, located
on the underside of the table at the rear of the saw.
4. Carefully move the trunnion (4) toward the right
or left side until the blade is parallel to the miter
gauge slot, and then securely tighten all four bolts
counterclockwise.
WArNINg
!
To avoid any injury, after adjustment, make sure all
four bolts (1, 3) are tightened securely.
Fig. X

front of Table View
Rear Outfeed
3
Rear of Table View
INSTALLINg THE rIvINg KNIfE (fIg. Y)
. Remove the table insert.
. Raise the blade to the maximum height with the
blade elevation handwheel.
3. Loosen the riving knife lock knob () (minimum of
three turns). NOTE: This lock knob does not come
off unit.
4. To disengage the riving knife lock pin, push the lock
knob in.
5. Insert the riving knife () into the slot (3) between the
plate (4) and the blade support arm.
6. Slide the riving knife down completely and release
the lock knob. The lock pin should snap into place.
7. Tighten the riving knife lock knob ().
NOTE: The riving knife has two positions, the high


3
4
position for all through cuts and the lower position for
all non-through cuts.
8. Replace the table insert back into its position on the
table.
WArNINg
!
Before connecting the table saw to the power
source or operating the saw, always inspect the
blade guard assembly and riving knife for proper
alignment and clearance with saw blade. Check
alignment after each change of bevel angle.
WArNINg
!
DO NOT operate the saw without the riving knife
locked in place, whether for through cutting or non-
through cutting positions.
Fig. Y
ALIgNINg THE rIvINg KNIfE TO BLAdE
(fIg. Z, AA)
WArNINg
!
To avoid injury from an accidental start, make
•
sure the switch is in the OFF position and the
plug is disconnected from the power source
outlet.
Never operate this tool without the riving knife in
•
the correct position.
Never operate this tool without the blade guard
•
in place for all through sawing operations.


3
4