Porter-Cable PCB222TS Instruction Manual page 17

Anti-kickback pawls storage (Fig. J)
Storage for the anti-kickback pawls () is located on the
right side of the saw housing.
. Place the anti-kickback pawls () on the bracket ()
for storing, make sure the protrusion (3) inside the
anti-kickback pawls () is engaged in the notch (4) on
the bracket ().
Fig. J


Riving knife storage (Fig. K)
Storage for the riving knife () is located on the right
side of the saw housing.
. Insert the riving knife () into the bracket (), make
sure the slot (3) of the riving knife is engaged in the
notch (4) of the bracket.
Fig. K

3
4
3

4
extra saw blade and blade wrenches storage
(Fig. L)
. Loosen and remove the knob () on the right side of
the saw housing.
. Place blade wrenches (), extra blades (not included)
onto the arbor. Replace the knob and tighten.
Fig. L


Power cord storage (Fig. M)
Wrap the power cord () on the two provided clips
located on the back of the saw base. NOTE: Do not
wrap the power cord around the dust port ().
Fig. M

INSTALLINg THE BLAdE ELEvATION HANdWHEEL
(fIg. N)
NOTE: UP-DOWN is printed on this handwheel.
. Bag "A"
_
Attach the blade elevation handwheel ()
to the elevation rod () at the front of the saw. Make
sure the slots (3) in the hub of the handwheel ()
engage with the pins (4) on the saw.
. Attach and tighten the crown nut (5) using a 3 mm
wrench.
7