Femto Network Gateway Configuration - Cisco ASR 5000 Series Administration Manual

Femto Network Gateway Configuration

Femto Network Gateway Configuration
The figure below shows the contexts in which FNG configuration occurs.
Mgmt
AAA
FAPs
Step 1
Set system configuration parameters such as activating PSCs/PSC2s by applying the configuration examples in the
System Administration Guide.
Step 2
Set initial configuration parameters by modifying the local context by applying the configuration example in the section
Initial Configuration.
Step 3
Create the FNG context, FNG service, AAA group configuration, EAP profile configuration, IKEv2 and IPSec
transform set configuration, and crypto template configuration by applying the configuration example in the section
FNG Context Configuration.
Step 4
Create the egress context and IPv4 address pool by applying the configuration example in the section
Configuration.
Step 5
Log system activity by applying the configuration example in the section
Step 6
Save the configuration by following the steps in the Verifying and Saving Your Configuration chapter in this guide.
OL-24872-01
1
2
Local Context
Mgmt Interface
Eth. Port
3
FNG Context
AAA Group
Cfg.
IPv4 AAA Interface
Eth. Port
Subscriber
Cfg.
FNG Service
IPv4 Secure I/F to FAPs
Eth. Port
Configuring the System to Perform as a Femto Network Gateway ▀
4
Egress Context
IPv4
Address
Pool
Egress Interface IPv4
Eth. Port
Logging Configuration.
Cisco ASR 5000 Series Femto Network Gateway Administration Guide ▄
IMS Core / PDSN
Egress Context
39