Emulator-Opened Sessions; User-Opened Sessions - IBM Terminal Emulation TN5250 User Manual

Emulator-Opened
Sessions
User-Opened
Sessions
Getting Started
If you have specified an IP address in your connection definition, then once
connected the Pass Through Screen displays (see Figure 1-2).
Figure 1-2 Pass Through Screen
Pass Through Screen
Type choices, Press Enter.
Remote location name
Mode name
Virtual controller
Virtual display device
Remote network identifier
Local PU name
Local LU name
An initial session has been opened by the emulator. From the Pass Through
Screen, press
(right) to go to the first open session. To open subsequent
Ctrl
. The main menu will display. Use the Sessions menu to
sessions, press
Alt + ?
open more sessions.
If you have not specified an IP address in your connection definition, then
Main Menu - TN5250 displays (the main menu of the TN5250 user interface).
Use this menu to open your initial session. You will need to open a session to
continue.
Note See Chapter 2, "The Menu System," for further instructions about
navigating through the TN5250 terminal emulation menu system.
To open a session:
1 Position the cursor at Open Session.
2 Press .
Ctrl
AS400A
LU62APPC
QPACTL00
___________
___________
MKPTU3
___________
1-5