Advertisement
2) QUICK SETUP (for instant gratification)
1) Plug your guitar using a 1/4" instrument cable into the INPUT on the far right of the front panel
2) Plug a suitable power cable from the OTS's rear panel MAINS cable inlet to your wall power receptacle
3) Plug the OTS into your speaker cabinet using 1/4" speaker cable
4) Set the IMPEDENCE selector to the match the impedance of your speaker cabinet
5) Plug the footswitch cable into the FOOT PEDAL jack on the rear panel of the amplifier
6) Set the OD TRIM control on the rear panel to 12:00 (clock face)
7) Set all rotary controls on the front panel to 12:00 (clock face)
8) Turn MASTER control to about 9:00 (clock face)
9) Set front panel MID BOOST switch in the down position (OFF)
10) Set front panel ROCK / JAZZ switch in the up position (ROCK)
11) Set front panel POWER switch in the upward ON position (with adjacent switch to STANDBY) for 30 seconds to allow
tube filaments to warm up
12) Set front panel STANDBY switch upward to the ON position
13) ROCK!!!!!!
3
Hide quick links:
Advertisement
