Table of Contents
Advertisement
H1/6 BLUE (-) instant trigger input
This input will respond to a negative input with an instant trigger. It is ideal for
hood and trunk pins and will report on Zone 1. It can also be used with Directed
single-stage sensors. The H1/6 blue instant trigger wire can also be used to shunt
Bypassing
sensors during operation of auxiliary channels or remote start. (See
Sensor Inputs
section of this guide.)
H1/7 VIOLET (+) door trigger input
This type of dome circuit is used in many Ford products. Connect the violet
wire to a wire that shows (+)12V when any door is opened. This wire will report
Zone 3.
NOTE: If using a door trigger wire that has a delay, Advanced Menu 2, feature
6 or the 998T Bitwriter can be used to turn Bypass Notification off.
H1/8 BLACK (-) chassis ground connection
Connect this wire to a clean, paint-free sheet metal location (driver kick
panel) using a factory bolt that DOES NOT have any vehicle component
grounds attached to it. A screw should only be used when in conjunction with
a two-sided lock washer. Under dash brackets and door sheet metal are not
acceptable ground points. It is recommended that all security components be
8
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.
Hide quick links:
Advertisement
Table of Contents
