Viper Responder 350 Installation Manual page 25

2-3 NUISANCE PREVENTION® CIRCUITRY (NPC®) ON/
OFF: ®
NPC stops repeated triggering of the same zone. If one zone is
triggered three times in one hour, that zone is bypassed for one hour, starting
from the time of the third trigger. During that hour, if the system detects a
trigger on that zone again, the system resets the one hour timer. If one hour
passes and the zone has not triggered again, the zone is activated and can trigger
®
the system again. NPC monitors sensor inputs and the door trigger, but does
®
not bypass the ignition trigger at any time. If NPC is turned off, the system
will respond to repeated triggers on the sensor inputs and will do so indefi-
nitely. Some states have laws regulating how many times a security system can
trigger before it is considered a nuisance and the vehicle is towed away.
2-4 PROGRESSIVE DOOR TRIGGER ON/OFF:
The system responds
to a door trigger input with a progressive response. When the door is opened
with the system armed, the siren will chirp 10 times prior to the full triggered
sequence. The door trigger is still treated as an instant trigger and closing the
door quickly will not prevent a full triggered sequence from occurring. If the
progressive door trigger is programmed off, the full siren output will occur the
moment the door is opened.
2-5 VALET PULSE COUNT ONE TO FIVE PULSES:
The system can
be programmed to count the number presses of the valet button before disarming
the security system or VRS®. The factory default setting is one pulse. The unit can
be set for two to five pulses using the two-chirp setting to select the pulse count.
Ghost Switch Option: For added security, the GRAY wire on the two-pin
Valet/Program can be connected to any switch in the vehicle that provides a
positive (+) momentary pulse.
2-6 Bypass Notification ON/OFF:
when programmed on, any active zone
input to the system during arming will generate a bypass notification chirp.
When programmed OFF, no bypass notification chirps will be generated if any
zone is active during arming.
2-7 Ignition-controlled DOMELIGHT SUPERVISION ON/OFF:
If turned on, the system will turn on the domelight for 30 seconds when the
ignition is turned off. The optional domelight supervision feature must be
installed.
25
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.