P P L L U U G G -I I N N H H A A R R N N E E S S S S E E S S; Super Bright Led; Valet/Program Switch - Clifford Matrix RS2 Installation Manual

Plug-In Harnesses
Super Bright LED, 2-Pin White Plug
The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as
the LED will be damaged. Multiple LEDs can be used, but they must be wired in series. The LED
can be top-mounted or flush-mounted. If top-loading the LED with a bezel, the LED fits into a
-inch mounting hole. If flush-mounting the LED from the back of a panel, drill a mounting hole
5 /
16
using a -inch drill bit. Be sure to check for clearance prior to drilling the mounting hole.
17 /
64
Valet/Program Switch, 2-Pin Blue Plug
The Valet/Program switch should be accessible from the driver's seat. It plugs into the blue port on
the side of the unit. Since the system features Valet by using the remote transmitter, the switch can
be well hidden. Consider how the switch will be used before choosing a mounting location. Check
for rear clearance before drilling a -inch hole and mounting the switch.The GRAY wire in the
9 /
32
two-pin plug may also be used as a (+) Ghost Switch input and can be connected to any (+) switch
in the vehicle. (See Feature Descriptions section of this guide.)
24
© 2001
Directed Electronics, Inc.