Procedure (Cont.); Increasing The Lamp's Life - Chauvet Legend 330SR Spot User Manual

Setup
Procedure
(Cont.)
Increasing the Lamp's
-10-
4. Using the lamp base, push the lamp down against the spring clips and then roll the
lamp out the top.
5. Remove the 2 wires connected to the lamp by the spade terminals.
6. Reverse the steps above to install the new lamp. Do not touch the glass with bare
hands.
Do not turn product on without a lamp!
· ALWAYS turn the lamp off by using the DMX controller or the product's control
panel, then wait at least 5 minutes before switching off the product. This will
Life
keep the fans running to extract any remaining heat from the product's head.
· DO NOT power cycle the product unless it is necessary.
· DO NOT re-strike the lamp immediately after turning it off. CHAUVET®
recommends waiting 5 minutes before trying to re-strike the lamp.
· DO NOT touch the lamp without wearing gloves to avoid leaving grease on the
bulb or on the contacts that could reduce the lamp's life.
· ALWAYS change the lamp when it has reached its recommended lifespan to
avoid the risk of lamp explosion.
Spade Connectors
Legend™ 330SR Spot User Manual Rev. 1