Advertisement
2.
Press and H H O O L L D D the Valet/Program switch.
3.
Turn the ignition on and then off.
4.
Release the Valet/Program switch.
5.
Press and release the Valet/Program switch.
The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:
L L E E D D F F L L A A S S H H E E S S
The LED will stop flashing when the ignition is turned on.
r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored.
© 2005 Directed Electronics—all rights reserved
S S H H U U T T D D O O W W N N M M O O D D E E
One
System timed out
Two
Over-rev shutdown
Three
Low or no RPM
Four
Transmitter Shutdown (or optional push-button)
Six
(+/-) Shutdown
Seven
(-) Neutral safety shutdown
Eight
Wait-to-start timed out
3 3 7 7
Advertisement
