Advertisement
necessary to program this feature off.
2 2 - - 1 1 3 3 D D I I E E S S E E L L T T I I M M E E R R — — W W A A I I T T - - T T O O - - S S T T A A R R T T /15, 30, 45 S S E E C C O O N N D D S S : : Default is the "Wait-to-Start" input control
wire, or programmable to ignore the input control wire by a delay of 15, 30, or 45 seconds. This feature
can be also programmed with the Bitwriter® and with a delay from 1 to 90 seconds.
2 2 - - 1 1 4 4 R R U U N N T T I I M M E E ( ( T T I I M M E E R R M M O O D D E E ) ) — — 1 1 2 2 , , 3, 6, 9 M M I I N N U U T T E E S S : : Selects the time in minutes that the system will
operate the engine until the system "times out". This is the maximum operation period and the system
may be shut down using a shutdown at any time. Using the Bitwriter®, the run time can be programmed for any
duration from 1-16 minutes.
t t a a c c h h l l e e a a r r n n i i n n g g
To learn the tach signal:
1.
DRW-96
2.
3.
4.
s s h h u u t t d d o o w w n n d d i i a a g g n n o o s s t t i i c c s s
The unit has the ability to report the cause of the last shutdown of the remote start system.
T T o o e e n n t t e e r r d d i i a a g g n n o o s s t t i i c c m m o o d d e e : :
1.
3 3 6 6
Start the vehicle with the key.
Within 5 seconds, press and H H O O L L D D the Valet/Program switch.
The LED will light constant when the tach signal is learned.
Release the Program switch.
Turn the ignition off.
© 2005 Directed Electronics—all rights reserved
Advertisement
