Table 18. Removal steps of wireless USB adapter or Intel Turbo Memory
1
Note: Step
is only for models with the wireless USB adapter. For models with the Intel Turbo Memory Minicard,
1
skip step
.
1
In step
, unplug the jack by using the removal tool antenna RF connector (P/N: 08K7159) or pick the connector
with your fingers and gently unplug them in direction of the arrow.
When installing: In models with the wireless USB adapter, route the antenna cable as shown in this figure and plug
the cable firmly into the jack on the adapter.
Step
Screw (quantity)
2
M2 × 6 mm, flat-head, nylon-coated (2)
1100 Palm rest or palm rest with fingerprint reader
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 75
•
"1030 Solid state drive (SSD) or hard disk drive (HDD)" on page 76
Torque
Color
Silver
0.181 Nm
(1.85 kgfcm)
.
Chapter 8
Removing and replacing a FRU
91