Table of Contents
Advertisement
Important notes
Watertight/dust-protected
Your Tablet PC is watertight in accordance with IPX5 / IPX8 and dust-protected
in accordance with IP5X (protective glass against dust deposits). The slot covers,
however, must be securely sealed in the event of contact with water or dust.
Protection class IPX5 stipulates that the tablet can be operated normally after it has been sprayed
with water for at least 3 minutes through an opening of 6.3 mm / 0.25" diameter and a flow
rate of 12.5 l water per minute at a distance of approximately 3 m / 118.11".
Protection class IPX8 stipulates that your Tablet PC can be operated normally after it has been
submerged in tap water for 30 minutes at room temperature and at a depth of 1.5 m / 59.05".
Furthermore, protection class IPX5 stipulates that the Tablet PC can be left in an environment with
dust particles of up to 75 μm diameter for 8 hours and can then still be operated safely.
To ensure that the device remains watertight and dust-protected, the covers for the
microSD card slot and SIM card slot must always remain sealed. Chapters
Page 29
sealed again. Otherwise, water could penetrate the Tablet PC and cause a malfunction.
Ensure that water in the headphones and microphone area is wiped away
immediately, or else a malfunction or electric shock could occur.
If the Tablet PC comes into contact with salt water, soft drinks or
sludge, it must be cleaned immediately.
Cleaning the Tablet PC
Always switch your Tablet PC off for cleaning.
Your Tablet PC is watertight and dust-protected, but you should nonetheless
prevent water or dirt from penetrating the Tablet PC and prevent
accessories from becoming wet or dusty.
The adapter and base station are neither watertight not dust-proof. Do not use them
in a bathroom, in a very humid environment or in locations in which it can rain.
Only use cleaning products designed for computers. Conventional household cleaners
and polishes can damage the label on the Tablet PC, the paint or the Tablet PC itself.
Only clean the display surface with a very soft, slightly damp cloth. Rough
rubbing with a dry cloth can damage the screen. Residual water drops
or dirt on the monitor can cause staining.
If the Tablet PC is cleaned with alcohol, thinner, petrol or solvent, the label
can become illegible or the paint can start to bubble.
Clean the charging contacts on the rear of the Tablet PC occasionally with a dry cotton
bud, etc. If the socket is dirty, the connection will deteriorate and inadequate battery
charging can result in failure of the power supply. In this case, clean the socket with a
dry cotton bud or similar. Ensure that you do not damage the socket during cleaning.
14
and
"Memory cards", Page 28
describe how ports can be opened and securely
"SIM card",
Fujitsu
Advertisement
Table of Contents
