Go Remote - PRESONUS StudioLive 16.0.2 Owner's Manual

3 Universal Control and VSL
3.8 Smaart System Check Wizards (StudioLive 16.4.2 and 24.4.2 only)

3.8.4 Go Remote

52
Click on the Output Check tab to use the Smaart Output Check Wizard. You will be
shown buttons for all outputs on your StudioLive. Click on an output's button, and
pink noise will fade in for three seconds. You can click on the button again to stop it.
To adjust the pink noise, use the fader on the right side of the page.
At any point during any of the Smaart System Check Wizards, you can
switch over to iPad control using SL Remote. This allows you to continue
to the next step of the Wizard without having to walk back to FOH, which
is especially useful when placing your measurement microphone.
1. Follow the instructions in Section 4.1 and network your iPad and Computer.
2. Launch SL Remote on your iPad. See Section 4.1.3 for more information.
3. Connect to you StudioLive from SL Remote. See Section 4.1.3 for more
information.
4. SL Remote will launch to a warning page telling you that the device is under test.
StudioLive Software Library
™
Reference Manual