PRESONUS StudioLive 16.0.2 Owner's Manual page 94

3 Software: Universal Control with VSL, Capture, and Studio One Artist
3.3 Virtual StudioLive
The graphic below identifies each controller labeled with its
corresponding control on the StudioLive and can be used as a
map to quickly learn how to navigate the Overview Tab.
3.3.3 VSL Channel Tab
For complete information , see Section 7.2.3 in your StudioLive 16.0.2 User Manual.
The Channel Tab provides a detailed overview of the Fat Channel parameters
for the selected Channel. The selected Channel will always be shown above the
Gate section. It is important to remember that you have continuous bidirectional
control. If you wish to grab a point in the EQ with your mouse, for example,
you will be changing the parameters both in VSL and on your StudioLive.
English
Español
Deutsch
Français
22 22 22
PreSonus StudioLive ™ 16.0.2 Quick Start Guide
Software: Universal Control with VSL, Capture, and Studio One Artist
3.3.4 Loading Scenes and Presets from VSL
For complete information, see Section 7.2.4 in you StudioLive 16.0.2 User Manual.
To load a Scene or preset from the Browser window, you simply select it and
drag it over the mixer or channel you wish to load it on. Scenes and presets
can be dragged from either the On Disk or the Device Memory section
of the Browser and dropped onto the Overview or the Channel tab.
Loading a Scene
Loading an Entire Fat Channel Preset
Loading an FX Preset
3
Virtual StudioLive 3.3
To load a new Scene on your StudioLive, select it from
the Browser window and drag it over the mixer in
either the Overview or the Channel tab. The window
will gray out, indicating that a new Scene is about to
be loaded. Please note: only the parameters that have
been enabled for recall on the StudioLive will be
recalled on the mixer.
See Section 5.1 for more details.
To load every component in a Fat Channel preset
(Gate, Compressor, EQ), select it from the Browser
window and drag it over any part of the desired
channel. If you drag it over any of the component
quick views, it will load only that component (e.g., if
you drag a preset over the Gate Quick View, only the
Gate will be loaded).
To load an FX preset, select it from the Browser
window an drag it over any part of the desired FX bus
in the Master section of the Overview tab. Once it is
loaded, you can use the FX Type menu to change the
effect and create new presets.
Note: At this time, VSL does not transfer the name of
the preset to the StudioLive. All FX presets loaded from
within VSL will be labled "Natural" in the FX menu on
your StudioLive.
23 23 23
English
Español
Deutsch
Français