Installation; Troubleshooting - Lindy HDMI 4K Premium C6 User Manual

User Manual

Installation

Important! Before starting the installation, please ensure that all devices are powered off.
VERY IMPORTANT: never use a network connection with any active LAN components for
the HDBaseT link – this may destroy the Extender !!!
The following steps are for an installation using HDMI equipment, if you are using DVI
equipment, please substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the HDMI Extender Transmitter unit using a HDMI cable
(maximum length 10m). If required you may connect a local HDMI monitor during installation
– this monitor must be disconnected when the HDBaseT connection is being used.
2. Connect one end of the Cat.6/7 cable (max. length 100m) to the HDBaseT link port on the
Transmitter and the other end to the Receiver. Use solid core installation cable of at least
Cat.6 UTP.
3. Use another HDMI cable (maximum length 10m) to connect your HDMI display device to the
HDMI output port on the Receiver unit.
4. For RS232 Extender functionality, connect a DB-9 cable on the Transmitter and on the
Receiver.
5. For additional Infrared remote signal functionality, connect the included IR cables to the units
and place the transmitter in front of the HDMI device's IR receiver.
6. For Ethernet functionality, connect your devices to the 10/100Base-T ports.
7. Plug the DC power supply into the HDMI transmitter unit and switch on.
8. Power on your HDMI Source and Display to complete the installation.
9. The LINK Led on the Transmitter and Receiver will illuminate when the HDBaseT Link
between the Transmitter and Receiver is established.

Troubleshooting

There is no display on the screen.
Check that the DC plug and jack used by external power supply are firmly connected. The
Power LED must be lit. If the LED is not lit on Transmitter please check/replace the power
supply. If the LED is not lit on Receiver but is lit on the Transmitter please re-check both
units by connecting them with a short (~2m) patch cable. If the situation remains please
contact LINDY Tech Support.
Check that the Cat.6/7 cable is plugged in correctly and that both Link Status LED are lit.
Check that the HDMI source and display are both powered on and active.
When using the HDBaseT link the local monitor on Transmitter HDMI Bypass port MUST be
disconnected!
Power off all the devices, then power on in this order: first, the Transmitter unit, then the
display and finally the HDMI source.
For several HDMI devices it may be helpful to unplug and replug their HDMI connection to
re-initiate the HDMI handshake and recognition.
Reduce the length of Cat.6/7 or HDMI cable used, or use a higher quality cable.
4
English