Arctic Spa Arctic Ocean Owner's Manual page 16

Clean filter reminder
This message is displayed every three months to remind you to replace the filter cartridge on the
spa. The display will start blinking with the message 'CLE'. Press any key on the keypad to clear
the message. Replace your disposable filter every three (3) months. (See Spa Maintenance for more
information)
Temperature Control (Up & Down Arrows)
These buttons are used to set the temperature of the water. The normal display shows the actual
temperature of the water. When either arrow button is pressed, the display will show the current
temperature set point and will keep showing it for 5 seconds after releasing the key. The arrow but-
tons will increase or decrease the set point in 1 degree increments between 15°C to 40°C (59°F to
104°F). The Set Point symbol indicates if the display shows the set point or the actual temperature
of the water. While the heater is on, the Heater indicator will show a steady triangle on the display
After a power down, the default set point is 39°C.
Pump 1 Button
Press the Pump 1 key to turn Pump 1 on at low speed. A second press will change
Pump 1 to high speed. A third press will turn Pump 1 off. Note: You may not be able
to shut Pump 1 off if in a filter or heating cycle. A built-in timer will shut Pump 1 off
20 minutes after it has been started, unless it has been manually shut off.
The Pump 1 ON triangular icon will appear solid on the display when Pump 1 is running at high
speed. It will flash when Pump 1 is running at low speed.
Note: Pushing and holding the Pump 1 button will lock the panel. See the section "Panel Lock" for
details.
Pump 2 Button (Optional)
Press the Pump 2 key to turn Pump 2 on High speed. A second press will turn Pump
2 off. If Pump 2 is left on, it will automatically shut off 20 minutes after it has been
started, unless it has been manually shut off..
The Pump 2 ON triangular icon will appear on the display when Pump 2 is running at high speed.
Pump 3 (On/Off Button) (Optional)
Press the Pump 3 key to turn Pump 3 on High speed. A second press will turn Pump
3 off. If Pump 3 is left on, it will automatically shut off 20 minutes after it has been
started, unless it has been manually shut off.
Note: If Pump 3 is not present, then this switch is used only for the Standby mode. (Use this when
you're checking inside the equipment bay, or while you're changing a filter.)
A long press (5 seconds) on Pump 3 key puts the system on standby. In Standby mode, the display
shows "OFF" for at least 10 seconds and all outputs are turned off for 30 minutes. If the heater is
16
16