Fusion ™ Jetting System; Venturi Controls; Jetting System - Arctic Spa Arctic Ocean Owner's Manual

When the water temperature climbs above 85ºF (29ºC), proceed to the next step.
9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).
10) Rotate diverters to centre position and press "Pump 2" button on topside control
panel for 5 seconds to activate the "Boost filtration system". When this system is enabled,
"BOO" is displayed on the screen. This will give 45 min of circulation and filtration to
disperse the chemicals.
11) You can set the temperature (between 38°C and 40°C or 100°F to 104°F) by pressing the
TEMP ( ) and TEMP (
up to temperature within 16 to 24 hours. Replace the spa cover while the temperature is
reaching the set point.
IMPORTANT: For safety, you can lock your desired temperature setting. Refer to the Topside
Control Panel section for details.
TM
Fusion Jetting System
With your Fusion
the Fusion diverter, the jets are activated in groups, known as jet systems. The jetting systems
TM
are selected by turning the diverter from one side to the other, or select both by leaving the di-
verter in the middle. The number of diverters you will have will depend on the model and series
of Arctic Spa you have. Feel free to consult your local dealer with any questions regarding the
function of this system, or just jump in and experiment for yourself.

Venturi Controls

The Venturi Controls allow you to control the intensity of the massage at each jet by
adjusting the mixture of air and water. Simply turn the venturi control lever counter
clockwise for a stronger flow and clockwise for a softer flow. Most jets are adjustable by turn-
ing the face of the jet counter-clockwise for a stronger flow and clockwise for a softer flow and
eventually off.
Arctic Chiller
The arctic chiller has no Freon, compressors, pumps or refrigeration mechanics.
1. Remove one access panel and attach the chiller in it's place.
2. Lower the temperature on your spa to the desired setting.
Note: Do not leave the cover off of the spa in direct sunlight, this can lead to heat distress and
void your warranty.
) buttons on the control panel. The spa will normally come
TM Jetting System, you can control the massaging action of your spa. Using
13
13