Wiring Diagram; Wiring Connections; Main Harness (H1), 12-Pin Connector; H2 Harness, 6-Pin Connector - Directed Security and Remote Start Installation Manual

Wiring Diagram

Control
Center
Antenna
LED
Button
Shock Sensor port

Wiring connections

Shock Sensor
(side view)

Main Harness (H1), 12-pin connector

H1/1 RED/WHITE
H1/2 RED
H1/3 BROWN
H1/4
H1/5 BLACK
H1/6 VIOLET*
H1/7 BLUE
H1/8 GREEN*
H1/9 BLACK/WHITE
H1/10 WHITE/BLUE
H1/11 WHITE
H1/12 ORANGE
* The door trigger wire will still need to be connected if the system is programmed with security features OFF to allow the system to enter the
programming modes.

H2 Harness, 6-pin connector

H2/1 LIGHT BLUE
H2/2 WHITE/BLACK
H2/3
VIOLET/BLACK
H2/4
GREEN/WHITE
H2/5 GRAY/BLACK
H2/6 LIGHT GREEN/BLACK
© 2012 Directed. All rights reserved.
Bitwriter
D2D port
Jumper Jumper
tachometer light ash
Sensitivity
Adjustment
(-) 200mA AUX TRUNK RELEASE OUTPUT
(+) CONSTANT POWER INPUT
(+) SIREN OUTPUT
NOT USED
(-) CHASSIS GROUND INPUT
(+) DOOR TRIGGER INPUT, ZONE 3
(-) INSTANT TRIGGER INPUT, ZONE 1
(-) DOOR TRIGGER INPUT, ZONE 3
(-) 200mA DOMELIGHT SUPERVISION OUTPUT
(-) REMOTE START ACTIVATION INPUT
(+)/(-) SELECTABLE LIGHT FLASH OUTPUT
(-) 500mA GROUND WHEN ARMED OUTPUT
(-) 200mA SECOND UNLOCK OUTPUT
(-) 200mA AUX 3 OUTPUT
(-) 200mA AUX 2 OUTPUT
(-) 200mA FACTORY ALARM REARM OUTPUT
(-) WAIT-TO-START INPUT
(-) 200mA FACTORY ALARM DISARM OUTPUT
Remote
Start port
Control Center button input (use blue 2-pin
connector from Control Center cable)
Control Center LED output (use white 2-pin
connector from Control Center cable)
To Remote
Start port
H
Relay
satellite port
5