Assembly; With The Help Of A Second Person, Carefully Tip The Tread; Mill Onto Its Left Side As Shown. Partially Fold The Frame; 75) So The Treadmill Is More Stable. Do Not Fully Fold The - Weslo WLTL29321 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included small allen wrench
mallet , wire cutters
For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART in the center of
this manual. Note: The assembly hardware and other small parts are packaged in separate part bags. Do
not open the part bags until instructed to do so.
1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the tread-

mill onto its left side as shown. Partially fold the Frame

(75) so the treadmill is more stable. Do not fully fold the

treadmill until it is completely assembled.

Open part bag A. Attach four Base Pads (40) to the
Base (11) with two 1 1/4" Tek Screws (87) and two 3/4"
Tek Screws (25). Attach a Wheel (37) to the right side of
the Base with a Wheel Bolt (36) and a Wheel Nut (38).
2. See drawing 2a. Make sure that there are two U-nuts
(97) in the lower end of each Upright (62, 76).
Identify the Right Upright (62), which has a large round
hole and a slot near the lower end. While a second per-
son holds the Right Upright near the Wire Harness (21),
insert the end of the Wire Harness into the round hole
and out of the upper end of the Right Upright.
Open part bag B. Slide the slot in the Right Upright (62)
onto the Upright Lock Bracket (47) (see drawing 2b). Slide
the Right Upright down until it reaches the Base (11). Make
sure that the Wire Harness (21) is not pinched. Attach
the Right Upright to the Base with two 2 1/2" Bolts (53)
and two Star Washers (9).
With the help of a second person, tip the treadmill onto
its other side. Attach the Left Upright (76) as described
above. (Note: There is not a wire harness on the left
side.) Attach the other Wheel (not shown) to the Base
(11) as described in step 1.
and your own phillips screwdriver
, adjustable wrenches
1
2
62
Round Hole
5
, and needlenose pliers
36
37
75
40
38 25
40
11
25
2a
97
76
62, 76
21
Slot
47
11
, rubber
.
40
87
40
87
2b
47
62
Side View
9
53