Rack Mounting - 3Com 3C510510B User Manual

R
ACK
Introduction
The Hub TR is supplied with two mounting brackets and four screws.
These are used for rack mounting and wall mounting the unit. When
mounting the unit, you should take note of the guidelines given in
Positioning The Hub TR overleaf.
Wall Mounting Hub TR Units
WARNING:
Disconnect all cables from the Hub TR unit(s)
before continuing. Remove the self-adhesive pads from
underside of the unit(s), if already fitted.
Fitting the brackets to wall mount one unit:
Place the Hub TR unit the right way up on a hard, flat surface with
the front facing towards you.
Locate a mounting bracket over the mounting holes on one side
of the unit, as shown in diagram 1 below.
Insert the two screws and fully tighten with a screwdriver.
Repeat the last two steps for the other side of the Hub TR unit.
M K
OUNTING
I
IT NSTRUCTIONS
To wall mount the Hub TR unit(s):
Ensure that the wall you are going to use is smooth, flat, dry and sturdy.
Attach a piece of plywood (12" x 20" x 0.5") securely to the wall if
necessary, and mount the Hub TR unit(s) as follows:
Position the unit(s) against the wall (or plywood) with the front of
the unit(s) facing sideways. Mark on the wall the position of the
screws holes for both wall brackets. Drill the four holes.
Using suitable fixings and screws (not provided), attach the
unit(s) securely to the wall (or plywood).
Reconnect all cables.
Rack Mounting Hub TR Units
The Hub TR is 1U high and will fit a standard 19inch rack.
WARNING:
continuing. Remove the self-adhesive pads from underside of
unit, if already fitted.
Place the unit the right way up on a hard, flat surface with the
front facing towards you.
Locate a mounting bracket over the mounting holes on one side
of the unit, as shown in diagram below.
Insert the two screws and fully tighten with a suitable screwdriver.
Repeat the two previous steps for the other side of the unit.
Insert the unit into the 19" rack and secure with suitable screws
(not provided).
Reconnect all cables.
Disconnect all cables from the Hub TR unit before