Manual Setup - IBM 21L4365 User Manual

If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
To disable the Windows energy
saving feature by clicking on the
S button and selecting
TART
S , C P ,
ETTINGS ONTROL ANEL
D , S S . Make
ISPLAY CREEN AVER
sure that the E
NERGY SAVING
check
FEATURES OF MONITOR
boxes are either empty, or that
the features are set to at least 20
minutes.
Your system may also have its
Power Saving utility enabled
through the Bios Setup Utility.
Refer to your system manual for
directions on disabling that bios
option.
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
diskette does not run on your system, perform
1. Have your computer and monitor turned on for at least 15 minutes until
the monitor and video adapter have warmed up.
2. You may wish to start the program you most often use so that you can
adjust for a "typical" screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use an Arrow button (
press the OSD Enter button
5. Using an Arrow button (
press once to select
indicators become illuminated (see page 17
6. Use the Arrow buttons to correct (as much as possible) for noise in the
video signal then press
7. Use an Arrow button to select
8. Use the Arrow buttons again to tune the image to your liking.
9. When finished, press the Exit button
You have completed the monitor setup.

Manual Setup

M
ANUAL
at the bottom of the monitor to display
- +
) to select the IMAGE LOCK icon
or
to access the function.
- +
), select
or MANUAL
. Left and right arrow adjustment
COARSE
).
to save the changes.
and press the
FINE
four times to exit from the OSD.
, however,
A S
UTO ETUP
or the setup
A S
UTO ETUP
.
S
ETUP
and
, press and then
button.
13