Call Hold; Call Waiting - Handcell DAG1000 Series User Manual

DAG1000/2000 Series FXS Voice Gateway User Manual
need only a simulation with the FXS port unit equipment linked together and set up calls
not registered.
Elements necessary to completing a direct IP call ：
1) Both DAG serial and other VoIP Device, have public IP addresses;
2) Both DAG serial and other VoIP Device are on the same LAN using private IP
addresses;
3) Both DAG serial and other VoIP Device can be connected through a router using public
or private IP addresses (with necessary port forwarding or DMZ).
Operation Process ：
1 ） Pick up the analog phone then dial "*47"
2 ） Enter the target IP address.
【 Note 】： No dial tone will be played between step 1 and step 2
Examples:
If the target IP address is 192.168.0.160, the dialing convention is *47,
192*168*0*160. Followed by pressing the "#" key or wait 3 seconds. Complete
signaling interactive soon after, he was called the unit can be heard ringing.
【 Note 】： You cannot make direct IP calls between FXS0 to FXS1 since they are using same
IP. It only supports the default destination port 5060.

2.2 Call Hold

Place a call on hold by pressing the "flash" button on the analog phone (if the phone has
that button). Press the "flash" button again to release the previously held Caller and
resume conversation. If no "flash" button is available, use "hook flash" (toggle on-off hook
quickly). You may drop a call using hook flash.

2.3 Call Waiting

Call waiting tone (3 short beeps) indicates an incoming call, if the call waiting feature is
enabled. Toggle between incoming call and current call by pressing the "flash" button. First
then
5