Table of Contents
Advertisement
DAG1000/2000 Series FXS Voice Gateway User Manual
4.4 Quick Setup Wizard
Quick configuration guide will guide users to configure the device step by step. Users only need
to configure network, SIP server and sip port in quick setup wizard. Basically, after these three
steps, users are able to make voice call through device.
4.5 Network Configuration
4.5.1 Local Network
DAG has two kinds of work mode: route and bridge. When DAG is set route mode, the
DAG will work as small router and NAT function has enabled. In this situation, WAN port is
normally connect to uplink router/switch or ADSL MODEM, LAN port used to connect local
computer or other network device(such as Ethernet switches, Hubs etc); When DAG is set
bridge mode, WAN and LAN port are the same. The DAG just work as two ports or four
ports Ethernet switch.
When it set to bridge mode, only need to configure WAN port IP address and DNS. If set
to route mode, default LAN port IP will display and it can be change by users. Network
configure interface as below:
15
Advertisement
Table of Contents
