ECS H67H2-M v 1.1 Manual page 56

Memory Timing Configuration
This item shows the information of Memory Timing Configuration.
CAS#Latency(tcl) (9)
This item determines the operation of DDR SDRAM memory CAS(colulmn address
strobe). It is recommanded that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
Row Precharge Time(tRP) (9)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# to CAS# Delay(tRD) (9)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
RAS# Active Time(tRAS) (24)
This item specifies the RAS# active time.
Intel Graphics Configuration
This item shows the information of Intel Graphics Configuration.
GT OverClocking [Disabled]
This item allows you to control the internal GFX Turbo mode.
Press <Esc> to return to the Performance Tunning page.
Press <Esc> to return to the M.I.B III menu page.
Auto Detect DIMM/PCI Clk (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.
Spread Spectrum (Enabled)
If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic
Interference) generated by the system.
B.O.M.P Technology (Enabled)
This item allows users to enable or disable B.O.M.P technology. This function can
run safe setting to setup menu when system boot fail 3 times.
Command Rate (Auto)
This item allows users to set command rate.
DIMM Voltage (Default)
This item allows users to adjust the DIMM voltage.
CPU Voltage (Default)
This item allows users to adjust the CPU voltage.
IMC Voltage (Default)
This item allows users to adjust the IMC voltage.
Using BIOS
51