Chapter 5. Multi-Burner Hardware Installation And Removal In Windows 2000 And Windows Xp; Removing The Multi-Burner Hardware; Windows 2000 - IBM 22P9176 User Manual

Chapter 5. Multi-Burner hardware installation and removal in
Windows 2000 and Windows XP
Windows 2000 and Windows XP operating systems have the native drivers for the
Multi-Burner. Therefore, when this drive is connected, Windows will automatically
install the appropriate driver and the drive will be ready to be used. You do not
have to perform any special installation or removal procedures.

Removing the Multi-Burner hardware

"Hot plug" is supported for the connection between the USB cable and the
computer; therefore you don't need to turn off the computer when you remove the
Multi-Burner. Follow the procedure below for removing the Multi-Burner for
Windows 2000 and Windows XP.

Windows 2000

1. Exit the program that uses the drive.
2. Confirm that the Write indicator of the drive is off.
3. Click the Remove icon on the tray.
4. Select removing drive. In this case, select the drive name assigned to the drive
5. The Safe to Remove Hardware confirmation window appears. Click the OK
6. Remove the plug of the USB cable from the USB terminal of the computer.
© Copyright IBM Corp. 2003
Attention:
v This drive will be recognized as "IBM Multi-Burner" by Windows Device Manager.
v In Windows 2000 operating systems, Service Pack 4 or later must be installed.
Attention:
Do not remove and reconnect the drive from or to the computer in rapid succession. The
drive may not be recognized. Reconnect the drive approximately 20 seconds after
removing.
Use the Tray icon for this procedure.
(D: in this figure).
button.
5-1