Configuration 1: Self Power (Ac Adapter) Configuration - IBM 22P9176 User Manual

Configuration 1: self power (AC adapter) configuration

The Multi-Burner is usually used with the self power (AC adapter) configuration.
Requirements
v Standard USB cable and power cable assembly (shipped with this option); IBM
v AC adapter (shipped with this option)
Specifications
Read and write CD and DVD media are supported.
Connecting the Multi-Burner using configuration 1
To connect the Multi-Burner to your system, complete the following procedure.
Refer to Figure 1-1 during installation.
Figure 1-1. Configuration 1: self power (AC adapter) configuration
1. Turn on your computer.
2. Using the USB cable A , insert the cable plug 1 into the USB connector of
3. Plug the standard USB connector 2 into the USB port of your computer.
4. Connect the AC adapter to the DC IN connector 3 on the Multi-Burner.
Part Number 22P9188
A
B
the drive while squeezing the two buttons on the connector.
Note: USB cable B is not required for this configuration.
Chapter 1. Multi-Burner quick install
1-3