York PACER 3503 Instruction Manual page 6

7.
A.
MIDDLE WIRE
HANDLE BAR POST
MOUNTING TUBE
8.
HANDLE BAR POST
MOUNTING TUBE
9.
10.
RECHECK
Recheck that all of the bolts are tightened securely for your safety and comfort.
Plug the power cable into a suitable AC outlet (220~240 Volt 50Hz).
Before you use the treadmill for the first time turn on the power switch and connect the
magnetic safety key.
Allow the treadmill to run for 10 minutes or so without anyone using it.
Check that the mat is tightened properly and runs smoothly.
* SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
PACER 3503 / 5
Rest the computer console on the front handle bar
COMPUTER
and connect the computer wire plug to the middle
WIRE
wire socket protruding at the top of the left handle bar
post securely.
NOTE TAKE CARE NOTE: TAKE CARE to ensure the wires are connected
B.
Attach the computer console fully onto the handle
bar post mounting tubes carefully as shown.
Push the extra length of wire down into the handle bar
posts gently while attaching the console.
NOTE: TAKE CARE to ensure the wire does
Secure the computer console to the handle bar post
mounting tubes by using, four allen head bolts and
star washers.
Attach the handle bar post top covers onto the handle
bar properly as shown.
NOW tighten all the bolts you have fitted. NOW tighten all the bolts you have fitted.
as tightly as possible.
MAKE SURE MAKE SURE you fit the connected wire inside of
the handle bar post mounting tube properly
before attaching the computer console as shown.
not get trapped when you attach the
computer console.
If the console will not align and fit
easily, loosen all the bolts fitted so far -
and try again.
#5532-74
X4
#5532-09
*