Nikon AF-S NIKKOR User Manual page 25

• If this lens is used with cameras not compatible with vibration reduction, set
the vibration reduction ON/OFF ring switch to OFF. With the Pronea 600i/6i
camera, in particular, battery power may become quickly depleted if this
switch is left ON.
3. Introduction
Thank you for purchasing the AF-S NIKKOR 500mm f/4G ED VR/AF-S NIKKOR
600mm f/4G ED VR lens. These are high performance lenses featuring special
Vibration Reduction (VR) and high-speed Internal Focusing (IF) mechanisms. They
also employ a Silent (S) Wave Motor to drive the focusing mechanism. Focus
preset is also provided.
Major features
b Two AF modes (p. 27)
Autofocus can be overridden by setting the focus mode switch to "A/M" or
"M/A" and manually focusing with the focus ring.
M/A: Autofocus can be overridden by manually focusing with the focus ring.
This mode should be used for fine-focusing.
A/M: Autofocus can be overridden by manually focusing with the focus ring, but
focus ring detection sensitivity is lower than in M/A mode. Use this mode
to avoid canceling the AF setting by unintentionally moving the focus ring.
b Limiting the range of autofocus (p. 28)
Focus time can be reduced by setting focusing limits.
For example, if a subject is at least 8 m (26.2 ft.) (AF-S 500mm)/10 m (32.8 ft.)
(AF-S 600mm) away, set the focusing limit switch to ∞ – 8 m (AF-S 500mm)/
∞ – 10 m (AF-S 600mm).
b AF-L/MEMORY RECALL/AF-ON (p. 28-29)
Focus distances can be locked and saved during autofocus (AF-L) and then
recalled by pushing the
the lens by setting switch to AF-ON.
b Vibration reduction* (VR II) (p. 29-30)
NORMAL: Reduces camera shake during handheld shooting or use of a
monopod. This mode allows pictures to be taken at shutter speeds approx. 4
stops slower than is possible with a non-VR lens, therefore expanding the
range of shutter speed options and making handheld or monopod telephoto
shooting much easier. Panning is also possible.
TRIPOD: Recommended mode to reduce camera shake when using a tripod.
With a super-telephoto lens, camera shake may occur even when the camera
is mounted on a tripod. TRIPOD mode reduces camera shake when shooting
with a tripod, especially with shutter speeds between 1/15 and 1 sec. It also
reduces image shake in the viewfinder.
* Under Nikon measurement conditions. The effects of vibration reduction vary
depending on individual and shooting conditions.
"
MEMORY RECALL
"
button. Autofocus is restarted on
En
25