ProForm 380 E User Manual page 10

8. With the help of a second person, hold a Bolt
Spacer (79) inside the lower end of the Left
Upright (73). Insert an M10 x 96mm Bolt (5) with
an M10 Star Washer (8) into the Left Upright and
the Bolt Spacer. Repeat this step with a second
Bolt Spacer (79), M10 x 96mm Bolt (5), and
M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(85). Tighten the M10 x 96mm Bolts (5) until the
heads of the Bolts touch the Upright; do not fully
tighten the Bolts yet.
9. Press a Base Cap (82) into the Base (85).
With the help of a second person, tip the treadmill
so that the Base (85) is flat on the floor.
10. Set the Console (87) face down on a soft sur-
face to avoid scratching the Console. Identify
the Right Handrail (90), which has a large hole
in the location shown. Hold the Right Handrail
near the Console. Attach the console ground
wire to the Right Handrail with a #8 x 1/2" Screw
(22).
Next, insert the console wire into the large hole
in the Right Handrail (90) and out of the top as
shown. Attach the Right Handrail with three
M4.2 x 19mm Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
8
5
8
79
83
85
9
82
85
10
90
1
Console
Ground Wire
22
87
10
73
Console
Wire
Large
Hole
1