If Using Detergent; Operating Instructions; Starting The Engine; Checking Engine Oil Level - Pacific hydrostar 97553 Set Up, Operating, And Servicing Instructions

6. Choose the right Nozzle (5) for the
job. Pull back the quick connect col-
lar and push the Nozzle onto the end
of the Wand. Make sure the quick
connect collar locks the Nozzle in
place.
• Red Nozzle - direct spray stream.
This Nozzle should only be used
on hard surfaces such as concrete
or metal. This Nozzle can damage
wood.
• Yellow Nozzle - 15° spray range.
This Nozzle is used to clean small
areas.
• Green Nozzle - 25° spray range.
This Nozzle can be used to clean
larger areas.
• White Nozzle - 40° spray range.
This Nozzle can be used to clean
very large areas. .
• Black Nozzle - This Nozzle is used
with pressure washer detergent.
detergent inlet Pressure
connection regulator
Knob
water inlet
Hose
connection
connection
7. Connect the water supply to the
Water Inlet Connection. The water
source must be able to provide a
SKU 97553 For technical questions, please call 1-800-444-3353.
minimum of five gallons of clean, cold
water per minute at 20 PSI. Only
use a hose that is rated to meet this
capacity.

if using detergent:

8. Read detergent directions. Connect
one end of the Detergent Inlet Hose
(8) to the Detergent Inlet Connection,
and the other end into the container
holding the detergent. Only use de-
tergents specified for use with Pres-
sure Washers. The Pressure Washer
will draw one gallon of detergent for
every seven gallons of water. Only
use the Black (low pressure) Nozzle
when spraying detergents.

OPerating instructiOns

read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.

starting the engine

inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
problems are found, do not use
equipment until fixed properly.

checking engine Oil Level

cautiOn! Your Warranty is VOID if the
engine's crankcase is not properly
filled with oil before each use. Before
each use, check the oil level. Do not
run the engine with low or no engine
oil. Running the engine with no or
Page 10