Adding And Registering A Speakerphone; Register A Speakerphone To A Telephone Base - AT&T TL80133 User Manual

Getting started

Adding and registering a speakerphone

Before using a new TL80133 speakerphone, you must register it
with an AT&T business phone, an AT&T CL, CRL, CLP, or TL series
home cordless phone, or a VTech DS, SN, or IS series home
cordless phone. All these compatible telephone systems are
purchased separately. Visit
complete list of compatible phones.
When first purchased or when the speakerphone is not registered,
the voice prompt "Not registered" plays once upon every key press.

Register a speakerphone to a telephone base

NOTES:
• Make sure the speakerphone battery is properly installed (see page 3).
• Make sure your telephone system is not in use.
• Keep the speakerphone out of the charger.
For AT&T models with
telephone base:
1. Press and hold the
four seconds.
The IN USE light turns on, or
•
The base displays Registering... Please wait.
•
2. Release the button.
3. Place the speakerphone in the charger.
• The CHARGE light flashes red and green
alternately to indicate the registration is in
progress. This may take up to five minutes
to complete.
4. Once registered, you hear a confirmation tone.
• To verify the registration is successful, press
the PHONE button, and check for a dial tone.
www.telephones.att.com
/HANDSET LOCATOR button on the
/HANDSET LOCATOR button for about
5
for a
CHARGE light
flashes red
and green