Connecting The Usb Nano Receiver - Silvercrest STMS 2017 A1 User Manual And Service Information

English

Connecting the USB Nano Receiver

If you still have your old keyboard and mouse connected to the computer, please
shut down your computer, disconnect the corresponding devices from the PC and
restart the computer.
Remove the USB nano receiver from its storage
compartment (see
Batteries").
Plug the USB nano receiver into a free USB port on
your powered-on computer.
The operating system will automatically recognize the new hardware and install
the required drivers. Depending on the operating system installed, the following
screen messages may appear:
®
Windows XP
When the receiver is connected for the first time, the operating system
®
Windows 2000/XP displays the message „New hardware detected". Wait until
the message „The new hardware has been installed and is now ready for use" is
displayed before using your mouse and keyboard.
®
Windows Vista , Windows
When the receiver is connected for the first time, the operating system Windows
®
Vista displays the message „Installation of appliance driver software". Wait until
the message „The appliances are ready for use now" appears. The mouse and
keyboard are now operational and ready to be used.
If the connection to the nano receiver is interrupted or if it is not
possible to establish a connection, remove the batteries from
the mouse and keyboard and re-insert them.
12
Wireless keyboard with wireless mouse STMS 2017 A1
the chapter "Inserting
®
7
the
Fig.: Miniature USB Receiver